It is recommended for grouting gap with of 10-50mmĪbove materials can change as per project location and approvals. Used in conditions that has heavy dynamic loads, high bearing strength, or high chemical resistance. It can be used to a minimum depth of 10mm.Įpogrout GP: Is a three component self-levelling free flowing grout.
It is a free flowing micro concrete suitable for large volume concrete repairs at thicknesses from 50 to 300 mm.Įmaco S23 NB: When mixed with water, it is a flowable micro concrete ideally suited to poured/cast application, typical for large volume repairs, honeycombing and other construction defects to all structural elements. piles caps repairs, traffic areas, etc.). Resurfacing substrates where high compressive strength and low permeability are required (e.g. Lanko 701 MCS: It is formulated for all structural repairs ranges to structural loss in columns and reinstatement of large structural sections of concrete. It can be applied on sound concrete, masonry or similar material in thickness ranging from 50 to 100 mm per layer. It can be used where high compressive strength is required. It can be used for thicknesses up to 5cm.Ĭonrep 311 MC: It is a non-shrink micro concrete for grouting and general void filling. It is formulated to produce a shrinkage compensating mortar with excellent adhesion. An adhesive for internal rendering, floor toppings, key plaster, cement screed, etc.Ĭonrep 301 GA: It is a non-shrink mortar for grouting and concrete repairing which can be used where high compressive strength is required. It is intended to serve for all concrete repairs on the project and any kind of buildings.Ĭorrobond PVA (Corrotech): This multipurpose material can be used both as a straight forward bonding agent for concrete construction joints and repairs, a sealer and/or an admixture in cement based mixes.